after sales service
Step B1,B2:Fasten the 6 bolts of the motor back and change the key we send you, install the shaft sleeve, and then put on the retaining ring.
Step B3:Install the flange, and fasten the 6 bolts
Step B4:Install the brake disk.
Step B5:Install the motor stator and fasten the 6 bolts. Check the air gap.
Step B6:Install the rubber seal.
Step B7:Remember to pull out the brake wire and then fasten the 4 bolts of the rear cover.
Step B8:Connect the brake wire onto the 2 terminals(+ and -)